Comments 26
Join the community to add your comment. Already a deviant? Log In
thanks for letting me in
I don't know if these groups active but if anyone could let me know what air dying clay works best with funko pop customs that would be amazing :3
I use Apoxy two-part clay! www.amazon.com/Apoxie-Sculpt-1…
Do you have to add water or just mold it
It's equal parts of each type of clay mixed thoroughly. Let it sit for about 5 minutes so it's not so sticky, then mold it however you want! The stuff adheres to most surfaces better than super glue. After about half an hour, it becomes hard enough to carve details into. At about 1 hour after mixing, I usually use a bit of water on my finger to smooth the surface. Let it cure for 24 hours, then you can sand or paint it.
View all replies
I have no idea if its active also. I post stuff here, but no 1 else has. As 4 air dry clay I using Staedtler Fimo most the time, but I will use a mix of DAS and Polyform Model Air (both r air dry) if I really need clay and the stor is all sold out of the Staedtler Fimo.
Thanks i had this air drying clay but it wouldn't stick to my pop